Publicité
6. To switch the apparatus off, let
go of the starting lever (17).
Due to the intelligent energy man-
agement system, the motor starts
after a delay.
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.
Auto/Eco mode
The cordless lawnmower automatically
launches in the last mode used when
turned on. You can switch between Auto
and Eco mode by pressing the Auto/Eco
switch button (20).
The illuminated auto/eco lamp indicates
the current mode of the cordless lawn-
mower.
Auto mode: the cordless lawn mower
adjusts the motor speed in
accordance with the load.
Eco mode:
the cordless lawn mower
runs at the lowest speed for
maximum battery life.
Checking the charge status
of the battery
The battery charge status indicator (
shows the state of charge of the battery
(
9).
Press the button for the charge level indica-
tor (
21) on the lower bar.
The charge level of the battery is indicated
by illumination of the corresponding LED
lights.
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
Working with the device
Observe noise protection rules and
other local regulations.
Regular mowing stimulates the grass to an
increased leaf formation, while at the same
time killing weeds. Therefore, the lawn be-
comes denser after each mowing process,
resulting in an evenly loadable lawn.
The first cut takes place roughly in April
when the grass is about 70 - 80 mm high.
During the main growing season, the lawn
is mowed at least once a week.
• Move the device at walking speed and
in lines which should be as straight as
possible. For a flawless mowing result,
the lines should always overlap by a
few centimetres.
• Adjust the cutting height so that the de-
vice is not overloaded. If this not done,
the motor may become damaged.
• Always move across slopes crosswise.
Take special care when going back-
22)
wards and pulling the device.
• Clean the device after each use, as
described in the section "Cleaning/
storage".
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do
not touch the moving blade.
There is a risk of injury.
GB
IE
33
Publicité
