Publicité
GB
IE
1. Hold the carrying handle (
lift the device or push the device down.
2. Grip the lever (7) for adjusting the cut-
ting height and move it past the ratchet
mechanism to the desired cutting
height.
The correct cutting height is between 25
and 45 mm for an ornamental lawn and
about 45 - 65 mm for a utility lawn.
A high cutting height should be
selected for the first mowing of the
season.
Inserting/removing the
rechargeable battery
Switch off the apparatus, remove
the ignition key (
for the blades to come to a stand-
still.
1. To remove the battery (9) from the de-
vice, press the release button (9a) on
the battery and pull the battery out.
2. To insert the battery (9), push the bat-
tery along the guide rail into the de-
vice. You will hear it click into place.
Recharging the battery
Allow a hot battery to cool before
charging.
Only charge the battery (4) when
the red LED on the charge status
indicator is on.
The charging time with the dual
charger is about 1 hour.
32
6) and
10) and wait
1. Remove the battery (9) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (9) in the charging
compartment of the battery charger (5).
3. Plug the battery charger (19) into a
mains outlet.
4. When the battery is fully recharged un-
plug the battery charger (19) from the
mains.
5. Remove the battery (9) from the charg-
er (19).
Switching on and off
The cordless lawnmower may only
be used with two batteries of the
Parkside X 20 V Team series.
1. Place the apparatus on a level
surface.
2. Lift the cover (
device housing and insert the
charged batteries (9) along the
guides into the device. You will
hear them click into place.
3. Insert the ignition key (10) in the
corresponding opening next to
the rechargeable battery (9).
The ignition key can only be in-
serted in one position. Take note
of the guide groove on the open-
ing next to the battery and on
the ignition key (10) (see small
image
4. Before switching the apparatus
on, make sure that it is not touch-
ing any objects.
5. To switch the
apparatus on, press
the release button
(16) and hold it down while
pressing the starting lever (17).
Let go of the release button.
8) on the
).
1
2
Publicité
