Chucking - Promac GHB-1330 Manuel Utilisateur

I.....Forward/ Reverse On/ Off lever
J....Top slide rotation lock nuts
K....Top slide lock
L....Cross slide lock
A....Longitudinal Travel Hand Wheel
B....Automatic feed lever
C....Half-Nut Lever (thread cutting)
D....Cross Slide Hand Wheel
E....Top Slide Hand Wheel
F....Tool post clamping lever
G....Threading dial
Fig 6
Fig 7
H....Tailstock Spindle Locking Lever
I.....Tailstock Locking lever
J....Tailstock Spindle Hand Wheel
K....Tailstock off-set adjustment

6.2 Chucking

Chuck removal:
Before removing the chuck from the spindle, place board
across the bed ways under the chuck.
Support the chuck while turning three cam locks ¼ turn
counter-clockwise.
Line up the two marks (A, Fig 9) for removal.
Carefully remove the chuck form the spindle.
Clean all contact surfaces.
Lift the chuck up to the spindle nose and press onto the
spindle.
Tighten in place by turning the cam locks ¼ turn clockwise.
8
Fig 8
Fig 9