Transport And Start Up; Transport And Installation; Assembly; Mains Connection - Promac GHB-1330 Manuel Utilisateur

A....Lathe bed
B....Carriage
C....Top slide
D....Cross slide
E....Four-way tool post
F....Headstock
E
C D
A....Apron
B....Tailstock
C....Lead screw
D....Feed rod
E....Gear box
F....Steady rest
G....Follow rest
I
H
H....Pulley cover
I......3-axis digital readout (option)
J.....Chuck guard
K....Tool post guard
F
B
A
Fig 2
J K
Fig 3

5. Transport and start up

5.1 Transport and installation

The machine will be delivered in a closed crate.
For transport use a forklift or hand trolley. Make sure the
machine does not tip or fall off during transport.
The machine is designed to operate in closed rooms and can
be bolted to the floor.

5.2 Assembly

If you notice transport damage while unpacking, notify your
supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with petroleum, diesel oil or
a mild solvent.
Unbolt the lathe from the shipping crate bottom.
Move the carriage and tailstock to the tailstock end of the bed.
Assemble lifting hook (parts fastened to the crate bottom) to
lift the lathe
(see Fig 4)
Caution :
The machine is heavy!
GHB-1330......600kg
GHB-1340A....650kg
Assure the sufficient load capacity and proper condition
of your lifting devices.
Never step underneath suspended loads.
Use a machinist's precision level on the bed ways and check
to make sure that the lathe bed is level.
Loosen mounting bolts, shim and tighten mounting bolts if
needed.
The lathe bed must be level to be accurate.

5.3 Mains connection

Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a
16 A surge-proof fuse.
Only use power cords marked H07RN-F
6
Fig 4