Machine Specifications; Technical Data; Noise Emission; Contents Of Delivery - Promac GHB-1330 Manuel Utilisateur

The rotating work piece and chuck can cause injury.
Thrown and hot work pieces and cutting chips can lead to
injury.
Chips and noise can be health hazards. Be sure to wear
personal protection gear such as safety goggles and ear
protection.
The use of incorrect mains supply or a damaged power cord
can lead to injuries caused by electricity.

4. Machine specifications

4.1 Technical data

GHB-1330:
Swing over bed
Swing over cross slide
Centre distance
Width of bed
Overall
Net weight
GHB-1340A:
Swing over bed
Swing over bed gap
Swing over cross slide
Centre distance
Width of bed
Steady rest capacity
Follow rest capacity
Overall
Net weight
GHB-1330/ GHB-1340A:
Spindle taper
Spindle nose DIN 55029 (Camlock)
Hole through spindle
Spindle speeds...8
Tailstock ram travel
Tailstock quill diameter
Tailstock taper
Cross slide travel
Top slide travel
Tool size max
Lead screw pitch
Longitudinal feeds..40
Cross feeds...40
Metric threads...23
Inch threads...32
Mains
Output power
Reference current
Extension cord (H07RN-F):
Installation fuse protection

4.2 Noise emission

Acoustic pressure level (according to EN ISO 11202):
Idling at maximum speed
330mm
197mm
760mm
186mm
1650 x 760 x 1200mm
600 kg
330mm
476mm
197mm
1015mm
186mm
6 – 67mm
6 – 70mm
1905 x 760 x 1200mm
650 kg
MT-5
D1-4
38 mm
70-2000 rpm
95mm
32mm
MT-3
160mm
68mm
16 x 16 mm
4mm
0,037–0,989mm/r
0,01–0,268mm/r
0,45–10mm/r
3-1/4 – 80 TPI
400V ~3L/PE 50Hz
1,5 kW (2 HP) S1
4 A
4x1,5²
16A
LpA 78,4 dB(A)
The specified values are emission levels and are not
necessarily to be seen as safe operating levels.
As workplace conditions vary, this information is intended to
allow the user to make a better estimation of the hazards and
risks involved only.
4.3 Content of delivery
GHB-1330:
Machine cabinet stand
Chip tray
Splash guard
160mm 3-jaw universal chuck
300mm faceplate
Four way tool post
Steady rest
Follow rest
Set of change gears
2 pcs. MT3 fixed centres
MT3/MT5 centre sleeve
Threading dial
Operating tools in tool box
Oil can
Lifting hook
Operating manual
Spare parts list.
GHB-1340A:
Machine cabinet stand
Chip tray
Splash guard
160mm 3-jaw universal chuck
200mm 4-jaw independent chuck
300mm faceplate
Four way tool post
Steady rest
Follow rest
Set of change gears
2 pcs. MT3 fixed centres
MT3/MT5 centre sleeve
Threading dial
Operating tools in tool box
Oil can
Lifting hook
Operating manual
Spare parts list.
(see end of document for detailed content)

4.4 Machine description

F
E
D
Fig 1
C
A
B