Software - Migatronic OMEGA 180 Manuel D'instruction

Adjustment of wire brake
The wire brake must ensure that the wire reel brakes
sufficiently quickly when welding stops. The required
brake force is depending on the weight of the wire reel
and the maximum wire feed speed. A brake torque of
1.5-2.0 Nm will be satisfactory for most applications.
Adjustment:
Dismount the control knob by placing a thin screw
-
driver behind the knob and thereafter pull it out
Adjust the wire brake by fastening or loosening the
-
self-locking nut on the axle of the wire hub
- Remount the knob by pressing it back into the
groove.
Connection of a water cooling unit
The module should be fastened under the welding
machine and the fitting (1) should be mounted. The
power cable (2) should be pulled through the hole on
the rear side of the machine. The protection fitting (3)
in the wire chamber should then be dismounted.
Thereafter the 4-poled plug (4) and the protection
fitting should be remounted. 2 screws (5) should be
dismounted on the fitting with the quick connections
(6). The fitting is pulled out and turned up side down
so the quick connections are at the top and remounted
(see drawing).
Mount the flow hose on the water cooled torch in the
quick connection marked with blue and the return
hose in the quick connection marked with red.
It will be necessary to inspect regularly the cooling
liquid level by means of the level control (7). The
refilling of cooling liquid takes place through the filler
neck (8).

SOFTWARE

It is necessary to read software inside the new control
unit by means of a SD card, if the control unit has
been exchanged.
The software is placed on a SD card which must
contain the folders and one or more of the files as
shown below. The folder names must be saved in BIG
letters and with the original names.
Software reading
• Insert the OMEGA SD-card in the slide in the
right side of the machine.
• Turn on the machine.
• The display flashes shortly with three lines.
• Wait until the set current is displayed.
• Turn off the machine and remove the SD card.
• The machine is now ready for use.
All machine user settings are deleted when
new software has been inserted. Therefore,
always remove the SD-card from the machine
after the software update. Thereby, continuous
software update is avoid each time the machine
is turned on.
20