Publicité
U1 New user
U2 Remove user
U3 Remove all
U4 Radio decoding
Self-Learning
U8
Rolling
A4 Parameter reset
1 = Step-by-step - The fi rst
command is to open and the second
to close.
2 = Sequential - The fi rst command
is to open, the second to STOP, the
third to close and the fourth to STOP.
3 = Open
4 = Partial opening
5 = Output B1-B2
Choose the function to be assigned
to the user.
Press ENTER to confi rm.
The free position in the memory is
shown intermittently for a maximum
of 10 seconds. During this phase,
send the code from the control
device.
Repeat the procedure to add other
users.
Remove one of the registered users.
Use the arrows to change the status from OFF to ON and press ENTER to confi rm.
Use the arrows to choose the number associated with the user you want to remove.
No. 1 > 250
Alternatively, the control device associated with the user you want to remove can be activated.
Press ENTER to confi rm.
"CLr" will appear to confi rm deletion.
OFF (Cancel operation)
ON (Run operation)
1 = All decoding (default)
2 = Rolling code
3 = TW key block
OFF (Default)
ON
OFF (Cancel operation)
ON (Run operation)
Register up to a maximum of 250 users and assign a
function to each one.
The operation can be carried out by using a
transmitter or another control device. The boards
that manage the control devices (AF - R700 - R800)
must be inserted into the connectors.
Remove all registered users.
Choose the type of radio coding for the transmitters
enabled to control the operator.
If you choose the type of radio coding for the
transmitters [Rolling code] or [TW key block], any
transmitters with a diff erent type of radio coding
saved previously will be deleted.
Save a new rolling code transmitter by activating
acquisition from a rolling code transmitter that has
already been saved. The saving and acquisition
procedures are explained in the transmitter manual.
Restore the factory confi gurations except for:[users],
[CRP address]
Publicité
