Publicité
Command and control devices
1
2
2
3
2
3P
2
4
2
7
Card reader • Transponder selector switch
S1
Insert the R700 card into the corresponding connector.
GND
See function [F14 Sensor type].
Keypad selector
To
Insert the R800 card into the corresponding connector.
B
See function [F14 Sensor type].
STOP button (NC contact)
See the [F1 – Total stop] function.
Control device (NO contact)
Open command
When the [F6 – Hold-to-run] function is active, a control device must be set to
OPEN.
Control device (NO contact)
Partial Opening command
See function [F71 - Adjusting partial opening].
Control device (NO contact)
Close command
When the function [F6 - Hold-to-run] is active, a control device must be set to
CLOSE.
Control device (NO contact)
Step-by-step command
Sequential command
See function [F7 - 2-7 command].
Antenna with RG58 cable
Use this terminal to connect the antenna.
Publicité
