Publicité
16. Disposal and recycling
The device is supplied in packaging to avoid
transport damages. This packaging is raw
material and can thus be used again or can
be reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plastics. Take
defective components to special waste disposal sites.
Check with your specialist dealer or municipal admin-
istration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
17. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Saw blade is loose after the
engine is switched off
Motor does not start
Incorrect turning direction for
motor
Engine not supplying power,
switches itself off automati-
cally.
5. Burnt points on the cutting
area during transverse cut
6. Decreasing saw power with
full motor speed
7. Workpiece jammed be-
tween saw blade and length-
wise aligning stop
36 | GB
Possible cause
Fixing nut not tight enough
a) Mains fuse blown
b) Extension cable faulty
c) Connections to the engine or
switch not OK, brake not vented
d) Motor or switch faulty
a) Capacitor defective
b) Incorrect connection
a) Overload due to blunt saw blade
b) Thermal protection tripped
a) Blunt saw blade
b) Incorrect saw blade
c) Longitudinal stop not parallel to
the saw blade
d) Sliding carriage not parallel to the
saw blade
Belt loosened
Longitudinal stop not parallel to the
saw blade
www.scheppach.com
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised col-
lection point for the recycling of old electrical and
electronic devices. Improper handling of waste equip-
ment may have negative consequences for the envi-
ronment and human health due to potentially hazard-
ous substances that are often contained in electrical
and electronic equipment. By properly disposing of
this product, you are also contributing to the effective
use of natural resources. You can obtain information
on collection points for waste equipment from your
municipal administration, public waste disposal au-
thority, an authorised body for the disposal of waste
electrical and electronic equipment or your waste dis-
posal company.
Remedy
Tighten fixing nut
M 20 left-handed thread
a) Check the mains fuse
b) See operating instructions, "Electrical con-
nection"
c) Have this checked by an electrician
d) See operating instructions, "Electrical con-
nection"
a) Have this replaced by an electrician
b) Have an electrician transpose the wall socket.
Phase inverter phase inversion
a) Insert sharpened saw blade
b) Can be switched back an again after cool-
down time
a) Insert sharpened saw blade
b) Insert saw blade for longitudinal cuts
c) Replacing the longitudinal stop
d) Align sliding carriage with the saw blade
Tension the belt, see Maintenance
Check the setting of the lengthwise aligning stop
Publicité
