Publicité
Adjusting the riving knife
• Undo the screw (3), insert the riving knife and
clamp it in place. The distance between the saw
blade and the riving knife (4)must not exceed 8 mm
and must be checked and, if necessary, readjusted
after each saw blade replacement. Never set the
riving knife tip deeper than the tooth base height
of the uppermost saw tooth. Set the riving knife tip
to a max. 2 mm under the peak of the uppermost
saw tooth.
The riving knife is an important safety device,
which guides the workpiece and prevents the
kerf closing behind the saw blade and the work-
piece rebounding. Note the thickness of the riv-
ing knife - see numbers stamped into the riving
knife. The riving knife must not be thinner than
the body of the saw blade and not thicker than its
kerf width.
Attention! Close the protective cover (5) again.
Risk of damage!
Extraction hose
Fig. "L1"
Connect suction hose Ø50 and fasten with hose
clamps.
Extraction port
Plug the suction port from the suction system onto
the rear ejection pipe and connect the clamp from the
suction hose to the cable on the suction pipe.
Tool holder
Fig. "M"
Insert the on-board tool for the Precisa 6.0 into the
tool holder, ready to hand.
Transverse cutting gauge
Fig. "N"
Screw the swivel part and sliding rail together
1 washer
Ø 6.4
1 clamping lever
M 6
Fit the stop rail to the swivel part.
2 flat round screws
2 wing nuts
Insert the transverse cutting gauge to the left or right
of the saw blade as required.
The locking at 0° as well as 45° is done with the
plug-in bolt and clamping lever.
32 | GB
M 6 x 25
M 6
www.scheppach.com
Table extension
Fig. "O"
Attach the table extension to the machine and tighten
the screws only hand-tight.
11 hexagonal bolts
16 Washer
5 hexagonal nuts
Level the table extension to the saw table with two
straight wooden slats or similar and tighten all screws.
Fit the hose bracket and connect the Ø 50 suction
hose.
Your Precisa 6.0 circular table saw is now assem-
bled.
Setup and calibration
Fig. "P"
Ensure that your Scheppach circular table sawis
standing on level and firm ground. Level out uneven-
ness in the floor.
To do so, on the frame feet
• Loosen the hexagonal nut (1)
• Carry out the height adjustment
• Tighten the hexagonal nut (1)
With the rubber buffers removed, the machine can be
bolted to the floor through the holes.
11. Start up
m ATTENTION!
Always make sure the device is fully assembled
before commissioning!
Observe the safety instructions before the com-
missioning.
All safety devices and aids must be installed.
After connecting to the mains, your Scheppach
Precisa 6.0 is ready for operation.
NOTE:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no
liability for damage to the device or caused by the
device arising from:
• Improper handling
• Failure to comply with the operating instructions
• Repairs carried out by third parties, unauthorised
specialists.
• Installation and exchange of Non-original Schep-
pach spare parts.
• Application other than specified
M8x16
Ø8
M8
Publicité
