Philips 9000 Serie Mode D'emploi page 8

English
8
100
%
Vacuuming and mopping hard floors
Using the Vacuum & Mop set-up
1 To charge the appliance, insert the power plug into the socket on the back of
the appliance. Then insert the adapter into the wall socket.
2 A value between 0% and 90% flashes on the screen to indicate that the
appliance is charging.
3 When the appliance is fully charged, the value 100% lights up on the screen.
After a few minutes, the display will switch off.
Warning: Store and charge the appliance at a temperature
above 5 °C and below 35 °C.
Tip: You can charge the appliance in the After-Clean & Storage station.
Tip: You can charge the appliance separately in a place that suits you best.
The clean water tank and the dirty water tank are already attached to the
appliance upon delivery. With the wet module attached to the AquaSpin nozzle,
you can clean hard floors.
Note: This Vacuum & Mop set-up is suitable for vacuuming and mopping at
the same time. It is not necessary to vacuum the floor before mopping.
The Vacuum & Mop set-up is suitable for vacuuming and mopping all types of