Philips 9000 Serie Mode D'emploi page 25

Removing blockages from the Vacuum & Mop set-up
Clearing blockages from the wet module
Clearing blockages from the AquaSpin nozzle
2 You can remove entangled hair or threads from the microfiber brushes by
sliding down the microfiber brushes with one hand.
Tip: You can also use a pair of scissors to cut hairs and threads that have
become entangled around the microfiber brushes.
The Vacuum & Mop set-up may become clogged. You may notice this when
more water gets on the floor than usual or when bigger dirt particles are no
longer sucked up and fall back on the floor. Below you can find the instructions
to remove blockages from different parts of the Vacuum & Mop set-up.
If there is a blockage in the wet module, first switch off the appliance and
remove the AquaSpin nozzle and the 3-in-1 handheld. Then remove the
blockage by moving the cleaning brush in the suction channel of the wet
module up and down.
If there is a blockage in the AquaSpin nozzle, it can be removed by moving the
cleaning brush up and down in the suction channel of the AquaSpin nozzle.
English
25