Philips 9000 Serie Mode D'emploi page 23

1
2
1
2
Cleaning the After-Clean tray
21 Place the wet filter back on the dirty water tank.
22 Place the dirty water tank back into the appliance.
23 Turn the microfiber brushes counterclockwise (1) and remove them from the
AquaSpin nozzle (2).
Tip: In case a microfiber brush is difficult to remove, you can use the
cleaning brush handle to unlock the microfiber brush.
24 To allow the microfiber brushes to dry, place the open ends of the brushes on
the designated holders of the After-Clean & Storage station.
Note: Drying can take approximately 24 hours.
If the After-Clean tray gets dirty, you can clean it by following the steps below.
English
23