Publicité
Installation of the metal blade
Steps:
Remove the safety cotter pin (if present).
-
Unscrew the lock nut (7) from the shaft by turning it clockwise. If necessary, block the
-
sensor head (2) using the Allen key (1) (see the above picture). Note: The lock nut has a left-
hand thread.
Remove the disc washer (6) and washer (5).
-
Use the Allen key (1) to block the scythe head. If necessary, turn the fastening disc (3)
-
slightly.
Position the blade (4), washer (5) and disc (6) as shown.
-
Screw on the lock nut (7) and tighten it counterclockwise using the ring spanner.
-
Attention! For safety reasons, the lock nut (C7) must be replaced with a new one after every
-
10 tool changes.
Reattach the cotter pin.
-
Remove the Allen key and check the freedom of movement of the cutting tool.
-
Installation of the lawn trimmer (thread spool)
Manual_FX-MS125_Int24_Rev1
52
Publicité
