Publicité
1.
As a replacement line, use a diameter of 2.4mm (.095in). The spool is suitable for line up to
6m (20ft) on the 10cm (4") head. Avoid using a larger cord, as this may affect trim
performance.
CAUTION: For safety reasons, do not use metal-reinforced cord
2.
Squeeze the slotted area on both sides of the spool housing to unhook the lower cap.
3.
Take out the spool and pull off the old cord. Put one end of the new cord through the spool
holes and pull it until the length between the two parts of the cord is the same.
4.
Wind the string in the correct direction as indicated on the cord.
5.
Hook each end of the string into the slot on the spool's edge and put the ends through the
eyelets on the housing. Make sure that the spring and washers are in place.
6.
Hold the spool against the housing and pull the ends of the cord to release it from the slot.
7.
Align the slot on the lower cap with the hook on the housing and press the cap against the
housing until it clicks into place.
Manual_FX-MS125_Int24_Rev1
60
Publicité
