Publicité
●
Use an undamaged nylon cutting head. Stop the device and check the nylon cutting head if
you hit a stone or any other obstacle. Never use a defective or unbalanced nylon cutting
head.
●
Before starting, after failure or impact, always check the device and make sure it is in good
condition.
●
Local regulations may limit the use of the device
Attention!
●
Always keep the device with the cutting tool in good condition. Note improper maintenance,
the use of non-compliant spare parts, or the removal or modification of safety devices can
cause damage to the device and severe injury to the person working with it.
●
Secure the device well during transport to prevent fuel loss, damage to the device, and
injury. Always fit the transport protection of the cutting blade before transporting or
stowing the device.
●
On devices with a clutch, check that the cutting attachment stops rotating when the engine
is idling.
●
Always check the device for loose fasteners, fuel leaks, damaged parts, etc., before each
use. Replace used parts before use.
●
It is necessary to take sufficient breaks and change the working position.
●
Do not store the device in a closed area where fuel vapours can reach an open fire from
water heaters, stoves, etc. Store the device in a well-ventilated area only.
●
IMPORTANT: When filling the fuel, ensure the engine is off and cooled down. Never refuel
when the device is running or hot.
Manual_FX-MS125_Int24_Rev1
46
Publicité
