Publicité
6. Hold the device and carefully pull out the starter rope until you feel the first resistance. This is the
starting position for the pull starter. Now pull the rope several times until the engine starts and runs.
Avoid pulling the rope to the end or letting it recoil by releasing the handle. Such actions may cause
the starter to fail.
IMPORTANT: The device is equipped with a centrifugal clutch so that the cutting tool starts
moving as soon as the engine is put into the start position by operating the throttle. When
starting the engine, place the product on the ground in a level, clear area and hold it firmly so that
neither the cutting part nor the throttle lever can come into contact with any obstacle when
starting the engine.
7. Allow the engine to warm up for a few minutes at idle after starting before starting work!
NOTE: If the machine does not start after repeated attempts, please read the troubleshooting chapter
NOTE: Always pull the starter rope straight out. Pulling the starter at an angle will cause the rope to rub
against the eyelet. The diagonal pull can cause the starter rope to fray or break. Always hold the starter handle
when the rope retracts. Never allow the rope to be thrown back from the pulled-out position. This could
damage the starter device
Warm start of the engine
1.
Place the device on a firm and flat surface.
2.
Switch the ON/OFF to 1.
3.
Slide the choke to the "OPEN" position.
4.
Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous, mainly fast pull will provide a strong spark and start the engine.
If the engine does not start, please proceed again according to "Cold starting the engine."
Manual_FX-MS125_Int24_Rev1
.
56
.
Publicité
