Publicité
24. Hints for accessories
●
Make sure that your product is only equipped with original accessories. Only use the original
parts that the manufacturer specifies. The use of any other accessories or attachments may
cause injury to the user and damage to the device.
●
Clean the device thoroughly, especially the fuel tank and air filter. After using the device,
remove all fuel.
●
If you approach a user of the device as a spectator, carefully attract his attention and
confirm that the user will stop the device. Please do not startle or distract the user.
Otherwise, you could cause an unsafe situation.
●
Never touch the nylon cutting head or metal blade when the device is running. If it is
necessary to replace the guard or cutting tool, be sure that the engine and cutting tools
have stopped.
●
The engine must be OFF before you change the device's working range.
●
If necessary, have the device repaired by an authorized workshop. If the device is defective,
do not continue to run it.
●
Never touch hot parts such as the exhaust, ignition cables, or spark plug when starting or
operating the device.
●
After the device has stopped, the exhaust pipe is still hot. Never place the device near
inflammable materials (dry grass, flammable gases or liquids, etc.).
●
Pay particular attention to the fact that the ground can be slippery when operating the
device in or immediately after the rain.
●
If you slip or fall to the ground, release the throttle immediately.
●
Before removing the blockage, stop the device and remove the spark plug connector. Before
adjusting or repairing the device, ensure the device is stopped and the spark plug socket is
removed.
●
Ensure that you do not drop the device or hit it against obstacles.
●
If the device is to be stored for a more extended period, let the device cool down first. Then
drain the fuel from the fuel tank and carburettor, clean the device and place it in a safe
place.
●
Carry out constant checks to ensure the safe and efficient operation of the device. For a
complete inspection, please get in touch with us.
●
Keep the device away from fire or sparks.
●
Be careful when using the device. There is a risk of kick-back and recoil.
●
Use extreme caution when using this device with the cutting blade. A cutting blade kick-back
is a reaction that can occur when the rotating cutting blade hits an object that cannot be
cut. This contact causes the cutting blade to stop for a moment and then suddenly repels
from the hit object with accelerated force. This kick-back reaction can be severe enough that
the operator loses control of the device. A cutter blade kick-back can occur without warning
if the cutter blade encounters an obstacle that becomes blocked or jams. This is more likely
in areas where it is difficult to see the material being cut. For easy and safe cutting,
Manual_FX-MS125_Int24_Rev1
47
Publicité
