Publicité
Heating suddenly stops
during operation and the
symbol
flashes on the
display.
Heating zones of the same
side (such as the first and
the second zones ) would
display the symbol
.
Fan motor sounds
abnormal.
The above are the judgment and inspection of common failures.
Please do not disassemble the appliance by yourself to avoid any dangers and damages to the induction
hob.
TECHNICAL DATA SHEET
Below is the sheet of household induction hob according to EU regulation No. 66 / 2014.
The testing method is in compliance with the requirements of EN 60350-2:2018+A1:2021.
Model identification
Type of hob
Number of cooking zones and/or areas
Heating technology (induction cooking
zones and cooking areas, radiant cooking
zones, solid plates)
For circular cooking zones or area:
diameter of useful surface area per
electric heated cooking zone, rounded to
the nearest 5 mm
For non-circular cooking zones or areas:
length and width of useful surface area
per electric heated cooking zone or area,
rounded to the nearest 5 mm
Energy consumption per cooking zone or
area calculated per kg
Energy consumption for the hob
calculated per kg
The power board is damaged.
Pan type is incorrect.
Pot diameter is too small.
The hob is overheated.
The power board and the
display board connection fails.
The display board of
communicate part is damaged.
The Main board is damaged.
The fan motor is damaged.
Information for domestic electric hobs
THI234P
Built-in hob
Induction cooking zones
Replace the power board.
Use a correct pan (refer to 'Pan').
The hob is overheated. Wait for temperature
to return to normal. Touch
hob.
Pan detection circuit is damaged, replace the
power board.
Check the connection.
Replace the display board.
Replace the power board.
Replace the fan.
Symbol
Zone 1: 16,0
Ø
Zone 2: 18,0
L
W
Zone 1: 194,4
EC
electric cooking
Zone 2: 183,7
EC
electric hob
EN-22
to restart the
Value
Unit
2
cm
-
cm
-
Wh/kg
189,1
Wh/kg
Publicité
