Publicité
7 Assembling the Saw
2
3
4
1
► Plug the mains plug (6) into an easily accessi‐
ble socket (7).
The charger (3) will run a self-test. The
LED (4) will glow green for about 1 second
and red for about 1 second.
► Routing the connecting cord (5).
► Insert the battery (2) in the guides in the
charger (3) and press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow
green and the battery (2) is being charged.
► When the LED (4) and the LEDs (1) on the
battery no longer light up: The battery (2) is
fully charged and can be removed from the
charger (3).
► If the charger (3) is no longer required: Dis‐
connect the mains plug (6) from the wall out‐
let (7).
6.3
Displaying the state of charge
1
► Depress the pushbutton (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4
LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.
Malfunction in chainsaw or battery.
0458-023-9601-A
6.5
The LED indicates the operating status of the
7
6
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
5
7
7.1
7.1.1
The bar and chain combinations that can be
used with the chain sprocket are listed in the
specifications,
► Switch off the chain saw, engage the chain
► Raise the grip (1) of the wingnut (2).
80-100%
60-80%
► Rotate the wingnut (2) counterclockwise until
40-60%
20-40%
► Remove the chain sprocket cover (3).
0-20%
► Remove the tensioning gear (4).
► Take out the screw (5).
► Place the guide bar (6) on the tensioning gear
The guide bar (6) may be either way round. The
logo on the guide bar may also be upside down.
► Insert and tighten down the screw (5).
LED on Charger
Malfunction in charger.
Assembling the Saw
Mounting and Removing the
Bar and Chain
Mounting the Bar and Chain
21.
brake and remove the battery.
1
3
the chain sprocket cover (3) can be removed.
5
4
(4) so that both pegs on the tensioning gear
(4) engage the holes in the guide bar.
English
2
6
5
4
49
Publicité
