Publicité
Problem
There is more water on the
floor or in the After-Clean
tray than usual.
The appliance leaves water
traces on the floor.
The appliance does not clean
as well as it used to.
Possible cause
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The dirty water tank is not
placed correctly.
You have moved the appliance
sideways.
You made strong turns with
the appliance.
You have lifted the appliance
over a threshold, carpet or
stairs.
You lifted the appliance up
from the floor immediately
after you switched it off.
The wheels are blocked.
The clean water tank is empty.
The water strips are blocked.
Solution
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the Vacuum & Mop set-up').
Place the dirty water tank into the
appliance properly (see 'AUTOCLEAN after
every use'). It is closed correctly when you
can hear a 'click' sound.
To prevent water traces on the floor, try to
make less strong turns with your AquaTrio
9000 Series and avoid moving the
appliance sideways. You can activate the
water absorption mode
cleaning mode button. All the remaining
water on your floor will be absorbed.
To prevent water traces on the floor, try to
make less strong turns with your AquaTrio
9000 Series and avoid moving the
appliance sideways. You can activate the
water absorption mode
cleaning mode button. All the remaining
water on your floor will be absorbed.
Make sure the microfiber brushes stay in
contact with the floor. Make sure water
absorption mode
is switched on before
you lift the appliance over a threshold,
carpet or stairs to prevent water traces on
the floor or to prevent water from
splashing from the AquaSpin nozzle (see
'Usage restrictions').
Switch on water absorption mode
absorb any remaining water. Move the
appliance forwards and backwards a few
times with water absorption mode
engaged before switching it off. If you
switch off the appliance and lift it up
immediately afterwards, the water that was
present between the brushes leaves a trace
of water on the floor (see 'Usage
restrictions').
Check the condition of the wheels. Remove
the dirt that blocks the wheels.
Refill the clean water tank (see 'Using the
Vacuum & Mop set-up').
Remove the two microfiber brushes, fill the
clean water tank with some water, and
switch the appliance on. Make small
English
45
by pressing the
by pressing the
to
Publicité
