Publicité
English
40
Information code
Cause
The dirty water tank is full.
The AquaSpin nozzle is not
connected (properly).
The AquaSpin nozzle is stuck.
This is a safety cut-off if
something is stuck in the nozzle
(for instance, a power cable or
a toy).
The LED nozzle is stuck. This is a
safety cut-off if something is
stuck in the nozzle (for
instance, a power cable or a
toy).
The air inlet openings are
blocked.
Solution
Empty the dirty water tank.
Connect the AquaSpin nozzle.
Check the brushes, bearings, motor parts,
and caps for hair or other obstacles and
remove them. If there are no obstacles,
switching the appliance off and on might
solve the problem.
Check the roller brush and the rest of the
nozzle for hair or other obstacles and
remove them (see 'Cleaning the roller
brush'). If there are no obstacles, switching
the appliance off and on might solve the
problem.
Check the air inlet openings for blockages
and remove them. If this does not solve the
problem, check the whole air passage for
blockages and remove them. For the
Vacuum only set-up, this refers to the
nozzle, tube, filter, vortex finder, long
crevice tool, and Mini turbo brush. For the
Vacuum & Mop set-up, this refers to the
nozzle, tube, and the wet filter.
Publicité
