Publicité
GB
84
2
17
STEP 6
Attach the handlebar (7) and computer (17) at handlebar
3
support (12).
1. Guide the handlebar (7) to the open handlebar mount on
4
the support tube (12) and then close the handlebar mount
10
over the handlebar (7). Then thread the two pulse cables up
through the openings on the support tube
7
2. Attach the handlebar cover (10) at the handlebar holder.
25
9
3. Screw the handlebar (7) in desired position at the
8
handlebar post (12) with spacer (9), washer (8) and
handlebar screw (25).
4. Push the plugs of the connecting cable (3) and pulse
cable (4) projecting from the handlebar support (12) into the
8 12
associated socket of the computer (17). The pulse cables
have the same plug connections and therefore no specific
assignment is necessary.
5. Place the computer (17) on the top of the the handlebar
support tube (12) without squeezing the cables and tight
firmly by using screw (2) and washers (84). The screws (2)
you find at backside of computer.
STEP 7
Attach the power.
1. Please insert the plug of adaptor (73) to the power plug
(83) at end of chain guard (79L).
2. Please insert the plug of adaptor (73) to the jack of wall
power (230V~50Hz).
CHECKS
1. Check the correct installation and function of all screwed
and plug connections. Installation is thereby complete.
2. When everything is in order, familiarize yourself with the
machine at a low resistance setting and make your individual
79L
adjustments.
Note:
Please keep the tool set and the instructions in a safe place
83
as these may be required for repairs or spare parts orders
becoming necessary later.
73
19
Publicité
