Publicité
RF Exposure Warning: This equipment complies
with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment must be
installed and operated in accordance with provided
instructions and the antenna(s) used for this
transmitter must be installed to provide a separation
distance of at least 0 cm from all persons and must
not be co-located or operating in conjunction with any
other antenna or transmitter.
2.
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
Radiation Exposure Statement: This equipment
complies with IC radiation exposure limits set forth for
an uncontrolled environment. This equipment should
be installed and operated with minimum distance of 0
cm between the radiator and your body.
PREPARING TO USE THE UNIT
WARNING! RISK OF CONTACT WITH BATTERY ACID. BATTERY
ACID IS A HIGHLY CORROSIVE SULFURIC ACID.
1.
Make sure the area around the battery is well ventilated
while the unit is in use.
2.
Clean the battery terminals before using the jump
starter. During cleaning, keep airborne corrosion from
coming into contact with your eyes, nose and mouth.
Use baking soda and water to neutralize the battery
acid and help eliminate airborne corrosion. Do not touch
your eyes, nose or mouth.
3.
Determine the voltage of the battery by referring to the
vehicle owner's manual and make sure that the output
voltage is 12V.
4.
Make sure that the unit's cable clamps make tight
connections.
6
Publicité
