Publicité
4.
See the section Connecting the Jump Starter to the
Battery for step-by-step instructions on connecting
the jump starter to the battery.
5.
The green
NOTE: If the vehicle battery is extremely discharged,
the initial current draw from the jump starter may
activate short circuit protection in the smart cable.
When the condition is corrected, the smart cable will
automatically reset.
6.
After a proper connection has been made, crank the
engine. If the engine does not start within 5-8 seconds,
stop cranking and wait at least 1 minute before attempting
to start the vehicle again.
NOTE: If the car does not crank a second time, check
the smart cable to see if the green
lit. If you hear beeping or an LED is flashing, refer to
the Troubleshooting section. When the condition is
corrected, the smart cable will automatically reset.
NOTE: Cold weather may affect the performance of the
jump starter's lithium battery. If you hear only a click
and the engine does not turn over, try the following:
With the jump starter connected to the car battery and the
green
on all lights and electrical accessories for one minute. This
draws current from the jump starter and warms the battery.
Now try to crank the engine. If it does not turn over, repeat
the procedure. Extremely cold weather may require two or
three battery warmings before the engine will start.
NOTE: If no activity is detected, the smart cable will
automatically shut off after 90 seconds, and the red
Fault and green
disconnect the clamps from the vehicle battery, and
then reconnect.
IMPORTANT: DO NOT attempt to jump start your vehicle
more than three consecutive times. If the vehicle
will not start after three attempts, consult a service
technician.
7.
After the engine starts, unplug the battery clamps from
the jump starter socket and then disconnect the black
clamp (-) and the red clamp (+), in that order.
8.
Recharge the unit as soon as possible after each use.
Ready LED on the smart cable should light.
Ready LED illuminated on the smart cable, turn
Ready LEDs will be solid. To reset,
12
Ready LED is
Publicité
