Publicité
JUMP STARTING A BATTERY WITH LOW VOLTAGE
If the vehicle's battery voltage is too low for the jump starter
to detect that the battery clamps are connected, there is a
manual start procedure.
1.
Make sure the clamps are correctly connected.
2.
Press and hold the
turn on the override mode. The green
be solid on.
WARNING! Following these steps overrides a safety
feature. It will energize the battery clamps and cause
sparking if they touch each other. In addition, if the
clamp connections are shorted or reversed, damage
to the unit, battery, and possibly the car's electrical
system will occur.
WIRELESS CHARGING
The wireless charging pad provides 10W of power to quickly
charge your compatible mobile devices.
1.
Consult your mobile device manufacturer to make sure
your device supports wireless charging.
2.
Place the compatible device face-up on top of the charging
pad.
3.
Charging should begin immediately after pressing the
Power button.
4.
When finished charging, remove your mobile device.
Press and hold the
off all functions or wait 15 seconds and it will shut off
automatically.
5.
Recharge the unit as soon as possible after each use.
CHARGING A DEVICE WITH THE USB PORTS
The unit includes two USB output ports. One port is USB-A
and the other is USB-C, which deliver up to 5V at 3A, 9V at
2A, or 12V at 1.5A. If using both USB-A and USB-C ports at
the same time, they will deliver up to 5V at 2.2A max. to each
port.
1.
Consult your mobile device manufacturer for proper
charging power specifications. Connect a mobile device
cable to the appropriate USB port.
2.
Charging should begin immediately after pressing the
Power button.
3.
Charging time will vary, based on the mobile device's
battery size and the charging port used.
Override button for 3 seconds to
Power button for 1 second to turn
13
Ready LED will
Publicité
