Publicité
TROUBLESHOOTING
Jump Starter
PROBLEM
The jump starter turns on,
but won't jump start my
vehicle.
All four LEDs flash
The jump starter will not
recharge.
When the battery cables are
connected correctly to both
the jump starter and the
battery there is a green
Ready LED blinking, a red
Fault LED off, and no beep.
SPECIFICATIONS
Internal Battery Type ......................................Lithium ion polymer
USB-C Input ..................................................... 5V DC, 3A | 9VDC, 2A
USB-A Output ....................... 5V DC, 3A | 9V DC, 2A | 12V DC 1.5A
USB-C Output ....................... 5V DC, 3A | 9V DC, 2A | 12V DC 1.5A
USB-A + USB-C Output........................ 5V DC, 2.2A + 5V DC, 2.2A
Charging Temperature .................... 32 ° F to 113 ° F (0 °C to 45 ° C)
Discharging Temperature ......... -4 ° F to 122 ° F (-20 ° C to 50 ° C)
Wireless Charging ...............................................................10W max
REASON/SOLUTION
Make sure the unit is
charged.
Verify the charge level of
the jump starter is at least
50%.
Do not attempt to jump
start your vehicle more
than three consecutive
times. If the vehicle still
does not start, consult a
qualified mechanic.
High temperature. LEDs will
stop flashing in 30 seconds.
Make sure the outlet or
power source is live.
"Fake" high battery voltage
is detected, but reverse
charging protection did not
activate. The user can crank
the car to jump start the
vehicle.
15
Publicité
