Publicité
Made
in
Germany
7.1 Maintenance plan
i
Before beginning service, disconnect from power. The work area around the lift is to be secured against unautho-
rised use.
Visual
Spray
inspection
Time frame
Position
Type of
maintenance
12
1
11
2
10
365 x / 12
9
3
4
8
5
7
6
12
1
11
2
10
365 x / 12
9
3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9
3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9
3
4
8
5
7
6
68
Oil
Lubricate
Check the polymer overlays and replace if required.
Model and information signs, labels, brief operating instructions, safety stick-
ers and warning information are to be cleaned and exchanged if damaged.
Check all available safety devices for function.
e.g.: CE stop, warning signal, blocking etc.
Exchange if damaged.
• Free the piston rod of the lifting cylinder of sand and dirt.
• Check the wiper for damage.
• Moving parts such as joint bolts and DU bearings, sliding pieces, sliding
surfaces and rollers are to be cleaned and checked for wear, exchange if
required.
• Lubricate all lubrication nipples with an acid-free multi-purpose grease. Do
not over-lubricate.
• Check the condition and function of the driving ramp.
• Check the condition of the cement floor.
• Check the torque of the fastening anchor. Also see the assembly protocol.
• The condition and function of the load suspension means are to be checked.
• Check the condition and function of all available safety devices.
All weld seams must have a visual inspection. Stop the system and contact the
manufacturer if there are cracks or breaks in weld seams of the lift.
Clean with
Clean
compressed
air
Maintenance plan
OPI_JUMBO LIFT 4000 NT_V4.1_DE-EN-FR-ES-IT
Inspect
Publicité
