Publicité
Made
in
Germany
9
7
7 Rollers
8 Supports
9 Ramps
Otherwise the supports (8) and ramps (9) can be dam-
aged.
• Secure the vehicle against rolling. Apply the hand-
brake, put into gear.
• Position polymer overlays below the receiving points
approved by the vehicle manufacturer.
i
If required, use the ramps for safe acceptance of the
vehicle. If the wheel base is too short, fold the ramps
underneath.
To receive the vehicle, the polymer
overlays cannot be placed on edge
otherwise there is a danger of the
car falling.
• Inspect the hazardous area.
No person or object may stand in the working area of
the lift, or on the lift.
• Switch on controls. Turn the main switch (1) to position
„1" (see figure 003).
• Lift the vehicle. Push the
• If the wheels are not blocked, interrupt the lifting process
and check for proper seating of the polymer overlays.
• Raise the vehicle to the desired working height. Push the
o
„Lift" (2) button.
5.3 Lowering the vehicle
• Inspect the hazardous area.
No person or object may stand in the working area of
the lift, or on the lift.
The vehicles cannot be lowered into the low-
!
est position without wheels. Otherwise the
lift cannot raise the load using its own force.
The vehicle could be damaged.
• Lower the vehicle to the desired working height or com-
pletely lower it. Push the
ure 003).
• The entire lowering process must be observed.
• If the lift is in the detectable lowest position, remove the
polymer overlays and drive the vehicle from the lift.
66
o
„Lift" (2) button.
u
„Lower" (3) button (see fig-
5.4 Balance the drive rails
See „Section 4.3 filling and venting the hydraulic system".
6
Behaviour in cases of error
8
Defective operational readiness of the system may be due
to a simple error. Check the system for the listed sources
of error.
004
If the error cannot be removed after an inspection to the
named causes, then inform customer service or your deal-
er.
Independent repair work on safety
devices of the lift and checking the
electrical system may only be done
by specialists.
Problem: Motor does not start
Possible causes:
No power supply
The main switch is not
switched on, or is defective
Defective fuse
The
o
"Lift" button is
defective
Motor has overheated
Motor defective
Problem: Motor starts, load is not lifted
Possible causes:
Load is too heavy
Hydraulic oil filling level is
too low
Emergency discharge
fixture is not closed
Pressure line leaking
Hydraulic pump defective
Remedy:
Check the power supply
Check the main switch
Have fuses checked
Inform customer service
Let the water cool.
Cooling time depends on the
ambient temperature.
Inform customer service
Remedy:
Unload the lift
Refill hydraulic oil
Check emergency discharge
fixture
Inform customer service
Inform customer service
OPI_JUMBO LIFT 4000 NT_V4.1_DE-EN-FR-ES-IT
Publicité
