Assembly - Cleanmaxx CP-CY4503ES-2 Mode D'emploi

Assembly

ATTENTION!
■ Risk of suffocation! Keep the packaging material away from children and animals.
■ Make sure that the device is not connected to the mains electricity supply before you
attach or remove the accessories.
• Unpack all parts and make sure that the product contents are complete (see chapter
"Product contents and device overview") and check for any damage from transport.
If you identify damage to the components, do not use them (!), instead contact our
customer service centre.
• Before using the device, remove all packaging materials and any labels that may be
on the device and are used for protection during transportation or for advertising.
Inserting/removing the suction hose
Inserting/removing the telescopic tube
Adjusting the length of the telescopic tube
A
Mounting/removing suction nozzles
• Insert the free end of the telescopic tube as far as it will go into one of the suction
nozzles supplied. At the same time twist the nozzle gently backwards and forwards.
• For greater fl exibility the suction nozzles can also be connected directly to the suc-
tion hose without using the telescopic tube.
• To remove a suction nozzle simply pull it out.
• Two of the suction nozzles supplied can be stored in the nozzle holder. The holder
is clamped to the telescopic tube.
23
• Insert the connection piece of the suction hose in the
suction opening on the device. It must audibly lock into
place.
• To remove the suction hose push the notches on the
connection piece and pull the hose out at the same time.
• Insert the open end of the handle into the corresponding
opening of the telescopic tube. At the same time twist the
handle gently backwards and forwards. Afterwards, check
the connection for secure seating.
• To remove the telescopic tube, pull it out of the handle.
• Pull the slider (A) on the telescopic tube down and set the
desired length.
• Release the slider and move the tube forward until it locks
into place.
EN