Cleanmaxx CP-CY4503ES-2 Mode D'emploi page 26

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
6. If required, rinse out the fi lters thoroughly with clear, lukewarm water.
Attention: Do not use any cleaning products!
Next shake off any surplus water and leave the fi lters to air dry completely before
replacing them in the device.
7. You can clean the cyclone insert and dust container with a damp cloth.
8. When all parts are dry, replace the cyclone insert in the dust container.
Please note: There is an arrow symbol on the top of the cyclone insert. Place the
cyclone insert into the dust container so that this arrow symbol points to the
symbol on the dust container.
9. After drying, place the foam fi lter back into the fi lter holder and replace the holder
onto the cyclone insert.
Attention: Never put damp parts back into the dust container!
11. Put the dust container in the device. Make sure that it audibly locks into place.
If the fi lters are damaged or worn you can order new fi lters at
www.service-shopping.de.
Cleaning the HEPA exhaust air fi lter
The HEPA exhaust air fi lter is situated behind the protective grill on the back of the
vacuum cleaner.
D
Next, shake off any surplus water and leave the fi lter to air dry completely before
replacing it in the device.
3. Brush or wipe the fi lter compartment if required.
4. Place the dry fi lter back in the fi lter compartment.
26
3. Carefully remove the cyclone insert (B) from the dust con-
C
tainer.
4. Pull the fi lter holder (C) out of the cyclone insert and re-
move the foam fi lter.
B
Please note: The second motor fi lter is attached to the
fi lter holder and cannot be removed from the holder!
5. Tap out all the parts over a bin and brush away any loose
dirt.
10. Put the lid on the dust container so that the arrow symbol
on the lid points to the
Close the lid by turning it as far as it will go. The arrow
symbol should now be pointing to the
dust container.
1. Pull up the exhaust hatch latch (D) and remove the hatch
simultaneously.
2. Remove the fi lter from the fi lter compartment and tap
it out over a garbage bin. If necessary, clean it with a
soft brush. You can also rinse the fi lter out under clear,
lukewarm warm water.
Attention: Do not use any cleaning products!
symbol on the dust container.
symbol on the

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Z 09666

Table des Matières