Rapid Recall Of Home Channel; Locking Microphone's Keypad; Signal Reception Attenuator - Alan HM35 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

a second time to exit the main menu and return to the standby
screen.

10.2 Rapid recall of home channel

This function allows you to quickly recall the channel most frequently
used (home channel).
1) Press the
button to access the command menu, then use the
buttons to highlight the Home Chan option.
2) Press
again to confirm the channel.
splay.

10.3 Locking microphone's keypad

If you use the MK06/35-K keypad microphone, you can lock its
keypad in order to avoid sending accidental commands during use.
1) Press the
button to access the command menu, then use the
keys to highlight the Lcd&Keypad option.
2) Press
again to view the available sub-menus.
buttons repeatedly until the Keypad Lock
3) Press the
sub-menu is highlighted.
4) Press
to insert an
. The device's keypad will be deactiva-
ted.
5) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen. The
icon will appear on the display.
To reactivate the keypad, follow the procedure outlined above (at step
4, remove the
).
When the keypad is locked, the On/Off-Volume knob, the
microphone PTT, and some function keys will still remain active
(depending on the device's programming).

10.4 Signal reception attenuator

If you are in an area where radio signals are too strong (e.g., near a
high-powered repeater or transmitter), you may find that these signals
saturate your receiver, reducing performance. To avoid this situation,
you can temporarily insert an internal signal attenuator as follows:
will appear on the di-
1) Press the
2) Press
3) Press the
distant) sub-menu is highlighted. To its left, you will see a D (di-
stant).
4) Press
5) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen.
In stand-by, the display will always show the current setting with
the
activated) icon.
As soon as conditions return to normal (e.g., you have moved
to an area where signals are not as strong), do not forget to
deactivate the attenator, otherwise you will not be able to re-
ceive weak signals.
To deactivate the attenuator, follow the procedure outlined above, se-
lecting D at step 4.
button to access the command menu, then use the
buttons to highlight the Radio Param option.
to view the available sub-menus.
buttons repeatedly until the Loc/Dist (local/
to select L (local).
(distant = attenuator deactivated) or
Advanced functions
(local = attenuator
27

Publicité

Table des Matières
loading

Table des Matières