External Speaker (Optional) - Alan HM35 Manuel D'utilisation

not be accessible.
1) Press the button to access the command menu, then press
buttons repeatedly until the Lcd&Keypad menu is
the
highlighted.
2) Press the again to view the available sub-menus.
button repeatedly until the Keypad Micr.
3) Press the or
sub-menu is highlighted, then press
pear beside the sub-menu to indicate that the keypad microphone
is active.
4) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen.
This procedure should be followed the first time you use your
microphone. If you are using the standard microphone, ensure
the is disabled by following the above procedure.
To connect/disconnect the MK06/35-K keypad microphone, follow
the same procedure as described for the standard microphone.
5.3.d External speaker (optional)
If you possess an external speaker, connect it to the Input/Output
[10] connector found on the rear panel of the device, referring to
Chapt. 13 and to the instructions supplied with the speaker itself. The
external speaker must be 8 Ohm and able to support a minimum of
12 W of power.
The output of the external speaker is grounded. Be careful not
to create short-circuits with the body of the vehicle.
The transceiver can be programmed so the external speaker
to confirm. A will ap-
is excluded and only the internal one is used. For further de-
tails, refer to par. 8.4.
Advice for installation
11