Monitor; Monitor From The Menu; Monitor Using The Microphone; Transmission - Alan HM35 Manuel D'utilisation

ground noise when no signal is being picked up. You can regulate the
threshold of device activation.
1) Press the button to access the command menu, then use the
buttons to highlight the Radio Param option.
2) Press the button once more to view the available sub-menus,
then until the sub-menu Squelch (adjustment of squelch
levels) is highlighted.
3) Press to access the sub-menu. SQUELCH will appear on the
display, and a horizontal bar will show the level of squelch inter-
vention currently being used.
4) Hold down the button until the background noise is continuous.
5) Now press the button to gradually increase the level of squel-
ch intervention, stopping as soon as the noise disappears.
6) Wait for a few seconds to ensure the noise has disappeared stably.
7) Exit the sub-menu by pressing the F4/ESC button, then press it
a second time to exit the main menu and return to the standby
screen.
Be careful not to set the squelch level too high: you may not be
able to receive weak signals.

6.6 Monitor

The monitor function is mainly used for two purposes:
• To allow for reception of extremely weak signals.
• To temporarily disable the CTCSS/DCS and/or selective calling to
allow you to listen to all communications on the tuned channel,
including those outside your network.
Each time the monitor function is activated,
display.
6.6.a Monitor from the menu
1) Press the
the menu.
2) Press
Monitor sub-menu is high lighted.
3) Press
function is active.
4) Exit the sub-menu by pressing the F4/ESC button, then press it a
second time to exit the main menu and return to the standby screen.
6.6.b Monitor using the microphone
If the monitor function has been activated (hang-up), you will activate it
each time you remove the microphone from its mount.

6.7 Transmission

1) Remove the microphone from its mount.
2) Ensure the channel is unoccupied (otherwise you will create interfe-
rence), and verify the status LED is off or flashing orange.
3) Hold down the push to talk (PTT) button on the hand-held mi-
crophone. The status LED [8] to the right of the display will light up
in red to confirm that you are transmitting.
4) Speak in a normal voice approximately 5 – 10 cm from the mi-
crophone.
5) Release the PTT at the end of the call, ensuring the status LED is no
longer lit.
will appear on the 6) At the end of the conversation, hang the microphone back up on its
mount.
button to access the command menu, then use the
buttons to highlight Radio Param (radio parameters) from
to view the sub-menus available and
to insert beside Monitor. This indicates that the monitor
Basic operations
until the
13