Publicité
metal scourers to clean the oven's glass door, as they may scratch the surface and cause the
glass to shatter.
Warning:
In the event of the glass surface breaking:
- immediately switch off all of the burners and any electrical heating elements, and isolate the
appliance from any energy sources,
- Do not touch the surface of the appliance,
- Do not use the appliance.
c. Installing and removing the side racks
To remove the side racks, press the clips indicated by the arrows
in the figure, firstly remove the bottom and the top side from the
installation notch. To reinstall the racks, you just need to repeat
the same operation but in reverse.
Rack 4
Rack 3
Rack 2
Rack 1
E – Replacing the oven light bulb
Warning:
Make sure that the appliance has been disconnected from the electrical
power supply before replacing the light bulb, to avoid any risk of electrical shock.
Bulb: 230 V ~ 15 W Max. E14 fitting.
1. Make sure that the buttons are in the "Off" position, then unplug the
2. Remove the protective cover. If you struggle to turn it, use a rubber glove.
3. Remove the bulb and replace it will a bulb which has specifications that
4. Replace the bulb, then put the cover back into place.
This appliance contains a light source with a G energy efficiency class.
7. QUICK TROUBLESHOOTING GUIDE
In each emergency situation, you need to:
- Set the oven's dials to the 0 position – "Off".
- Unplug the appliance from the power source
- Contact the after-sales service
Rack and baking tray positions
It is important that you properly position the rack in the
oven. Do not let the rack touch the rear panel of the oven.
The positions of the rack are shown in the figure. You can
also place a tray, or a drip tray (generally in the lower
section) for certain dishes or to catch cooking juices.
appliance from the power supply.
Clean it and fully dry it.
are identical to those of the original.
23
EN
Publicité
