Publicité
Connection diagram
EN
Warning:
home's power supply corresponds to the voltage indicated on the appliance's information
panel. The technical data and electrical connection conditions are indicated on the appliance's
information panel. This appliance must be installed and connected to the mains supply only by
a qualified technician. This appliance must be earthed: only use an electrical cable with a suitable
cross-section and a earth wire (yellow/green).
Warning:
not touch hot surfaces on the appliance.
Warning:
circuit breaker (ELCB) with a minimum contact gap of 3 mm.
Warning:
applicable standards (the switch must not disrupt the earth wire).
Warning:
the electrical connections overheating. The power cable (supplied) must be installed in such a way
as never to exceed the ambient temperature by more than 50°C over its entire length. Before
connecting the appliance, check that:
- The electrical installation can support the load of the appliance (see specifications table).
- The electrical installation must be effectively earthed, in accordance with the applicable
standards.
- The socket or multi-pole switch is easily accessible once the cooker has been installed in its final
position.
220-240V~50/60Hz
Neutral
Phase
Earth
H05 VV-F 3G 4 mm
Before plugging in your appliance, make sure that the voltage of your
Always connect the protective earth wire. Make sure that the power cable does
This appliance must be connected to the mains supply via an earth leakage
This circuit breaker must be sized according to the load and comply with
Do not use extension cables, multi-socket strips or adapters, as this may lead to
380–415V 3N~50/60Hz
L3
Neutral
L2
L1
Earth
H05 VV-F 5G 1.5 mm
2
2
16
380–415V 3N~50/60Hz
220–240V~50/60Hz
L2
Neutral
L
L1
Earth
H05 VV-F 4G 1.5 mm
H05 VV-F 3G 4 mm
2
N
Neutral
Earth
2
Publicité
