Publicité
20. Stitch fi nger control
The stitch finger must be pulled back for rolled seams. To do so, set the
stitch finger control to "R".
1. Switch off the machine.
2. Open the looper cover (13).
3. Disengage the upper knife (14), as described in section "18. Disengag-
ing the upper knife" on page 245.
4. Slide the stitch finger control (46) to "R".
5. Set the cutting width to "R".
6. Set the upper knife back to the original position.
7. Close the looper cover.
The stitch finger control must be set to "S" for all standard overlock stitches.
1. Switch off the machine.
2. Open the looper cover.
3. Disengage the upper knife, as described in section "18. Disengaging
the upper knife" on page 245.
4. Slide the stitch finger control to "S".
5. Set the upper knife back to the original position.
6. Close the looper cover.
DE
FR
NL
ES
IT
EN
247
Publicité
