Publicité
Les langues disponibles
Les langues disponibles
Replacing the dust filter
Dust filter housing cover
1
Screw
2
Flange
3
1. Release the lock of the sweeping mechanism hood by
turning it inwards.
2. Pivot up the sweeping mechanism hood.
3. Remove the dust filter housing cover.
4. Remove the screws (2x).
5. Turn the flange counterclockwise and remove the dust
filter bearing.
6. Remove the dust filter.
7. Fit the new dust filter so that the holes on the front point
to the driver.
8. Fit the dust filter bearing, turn clockwise and screw tight.
9. Fit the cover and latch into place.
10.Close the sweeping mechanism hood.
11.Secure the hood lock by turning it outwards.
Replacing the side brushes
1. Unscrew the screws (3x).
Screws
1
2. Remove the side brush.
3. Push on the new side brush.
4. Screw in and tighten the 3 screws.
Replacing the roller brush
Sheet metal cover
1
Screw
2
Waste container
3
1. Pull out the waste container.
2. Unscrew the screw.
3. Pivot the sheet metal cover upwards and remove it.
Bowden cable
1
Swing arm bearing screw
2
Bar cover
3
Rocker
4
Cover screws
5
4. Unhook the Bowden cable.
5. Unscrew the screw of the swing arm bearing.
6. Pull off the rocker.
7. Unscrew both screws of the cover and remove the cov-
er.
8. Remove the roller brush.
9. Fit the new roller brush.
10.Assemble the sweeping mechanism in the reverse or-
der.
11.Adjust the Bowden cable.
If there is a risk of frost:
1. Empty the fresh water tank and the waste water tank.
2. Park the device in a frost-protected room.
English
Frost protection
27
Publicité
