Publicité
Battery indicator
Wet battery variant:
The charging state of the batteries is shown on the control
panel display.
● The length of the bar shows the battery charging state.
Li-Ion battery variant:
The battery charging level is displayed on a separate
screen of the battery system.
● The percentage SoC (State of Charge) indicates the
charge state.
Unpacking
Note
Set the safety switch to the "0" position to shut down all
functions immediately.
1. Remove the packaging film.
2. Remove the strap.
3. Unscrew the unloading planks and squared timber from
the pallet.
Squared timber
1
Unloading plank
2
Block
3
4. Place the squared timber in front of the pallet.
5. Place the unloading plank on the squared timber.
6. Screw on the unloading plank.
7. Push the block provided in the packaging under the
ramp to provide support.
8. Remove the wooden strips in front of the wheels.
Squared timber
1
Unloading plank
2
Block
3
9. Push the device forwards off the pallet.
Pushing the device off the pallet
Note
Install the suction bar only after unloading.
1. Release the parking brake via the lever (see chapter
Pushing the device ).
2. One person must sit on the seat and press the brake
pedal in the case of danger during pushing.
3. Push the device down the ramp and off the pallet.
4. Close the parking brake with the lever.
The batteries must be installed and charged in order to
drive off the pallet.
Note
Install the suction bar only after unloading.
1. Insert the Intelligent Key into the control panel.
2. Switch on the device using the Easy-Operation switch.
3. Set the program switch to transport travel.
4. Set the travel direction switch to "Forward".
5. Depress the accelerator pedal.
6. Drive the device slowly off the pallet.
7. Switch off the device using the Easy-Operation switch.
Installing the brushes
The disc brushes must be installed before starting up (see
chapter ).
The brushes are installed.
Installing the suction bar
1. Pivot both clamping levers upwards.
Suction hose
1
Suction bar suspension
2
Clamping lever
3
Suction bar
4
Suction lip with strap
5
2. Insert the suction bar in the suction bar mount.
3. Pivot both clamping levers downwards.
English
Driving off the pallet
BD Variant
BR variant
15
Publicité
