Publicité
6. Release the accelerator pedal.
The device stops.
The driving motor switches off when overloaded. A fault
message appears in the display. If the controller over-
heats, the affected motor is switched off.
7. Allow the device to cool down for at least 15 minutes.
8. Set the program switch to "0", wait briefly and set to the
desired program.
Adjusting the driver's seat
3-stage weight adjustment 60-120 Kg
1
Backrest tilt adjustment 3° forward and 13° backward
2
Seat length adjustment
3
1. Operate the seat adjustment lever.
2. Move the seat to the desired position.
3. Release the seat adjustment lever.
Adjusting the steering wheel
1. Release the wing nuts for adjusting the steering wheel.
2. Position the steering wheel.
3. Tighten the wing nuts.
Checking the fluff filter
ATTENTION
Damage to the suction turbine!
Operating without a fluff filter can damage the suction turbine.
Do not operate the device without the fluff filter.
1. Check the following fluff filter aspects before starting up
the device:
Is it present?
Is it in a usable condition?
Is it installed correctly?
Fluff filter
1
2. Replace a damaged fluff filter.
1. Release the parking brake by pulling the lever away.
Note
The lever must be pulled all the way.
DANGER
Danger of injury from rolling device!
The parking brake can only be released while bent over
and staying in the hazard zone.
Use an object to hold the lever in a permanently pulled
state and move away from the hazard zone immediately
after opening the parking brake.
Parking brake lever
1
2. Push the device.
3. Close the parking brake again by releasing the lever.
Filling with fresh water
Filling with fresh water
1. Open the fresh water tank cap.
2. Secure the fresh water hose with the clamp.
3. Fill fresh water (max. 60 °C) to approx. 5 cm below the
filler funnel.
Note
Fill the fresh water tank completely before initial startup in
order to vent the water pipe system.
4. Remove the fresh water tank cap.
Filling fresh water with the fresh water tank automatic
Note
We recommend that you use a hose with an Aquastop cou-
pling on the device side. This minimizes the splashing out
of water when disconnecting after the filling process.
1. Connect the water hose to the automatic filling system.
2. Open the water inlet (max. 60 °C, max. 10 bar).
3. Monitor the filling process, the automatic filling system
interrupts the water inlet when the fresh water tank is
full.
4. Close the water inlet.
5. Remove the water hose.
English
Pushing the device
filling system (option)
17
Publicité
