Publicité
Preventing damage to device
8 • seca 777
WARNING!
Risk of infection
► Before and after every measurement, wash your hands to reduce
the risk of cross-contamination and nosocomial infections.
► Should the patient have contagious diseases, subject the device to
a hygiene treatment as described in the relevant section of these
instructions for use immediately afterwards.
► Ensure that the patient does not have any open wounds or infec-
tious skin alterations which may come into contact with the device.
► Subject the device to a hygiene treatment at regular intervals.
NOTICE!
Damage to device
► Ensure that fluids never get inside the device. These can destroy
the electronics.
► For devices with power supply operation: Switch off the device be-
fore you disconnect the power supply unit from the power supply
socket.
► For devices with power supply operation: If the device is not to be
used for an extended period, disconnect the power supply unit
from the power supply socket. Only then is the device de-ener-
gized.
► For devices with battery or rechargeable battery operation: If you
are not using the device for an extended period of time, remove
batteries or rechargeable batteries. Only then is the device de-en-
ergized.
► Do not drop the device.
► Do not subject the device to shocks or vibrations.
► Perform a function check before each use as described in the cor-
responding section in this document. Do not operate the device if it
is not working properly or is damaged.
► Do not place the device in direct sunlight and ensure that it is not
placed in the direct proximity of a heat source. The excessive tem-
peratures could damage the electronics.
► Avoid rapid temperature fluctuations. If the device is transported so
that a temperature difference of over 20 °C occurs, the device
must be left to stand for at least 2 hours before it is switched on,
otherwise condensation may form; this may damage the electron-
ics.
► Use the device only in the intended ambient conditions outlined in
the section entitled "Technical data".
► Store the device only in the intended storage conditions outlined in
the section entitled "Technical data".
► Use only cleaning agents and disinfectants which match the details
in the section entitled "Hygiene treatment".
► For scales: Ensure that maximum capacity is not exceeded.
Publicité
