Publicité
Fitting the column (white)
7. Extend the upper telescopic element far enough to expose the upper as-
sembly bore in the lower telescopic element.
8. Place a slot-head screw in the upper assembly bore and the spacer sleeve
underneath it.
9. Tighten the slot-head screw (torque: 2 Nm).
10. Push the upper telescopic element back into its lowest position.
Proceed as follows to fit the column to the weighing platform:
1. Lie the column on the floor and position the weighing platform as shown in
the diagram.
2. Hold the weighing platform steady.
3. Push the column and measuring rod into the openings in the column holder
of the weighing platform.
ð The screws on the column protrude from the underside of the weighing
platform.
English
Starting up device • 17
Publicité
