Publicité
Check/replace carbon brushes
Check the carbon brushes for proper function after 50 operating hours of the new machine,
subsequently every 10 operating hours. If the carbon is worn or the spring is damaged, replace the
carbon brushes as described below.
The carbon brushes may only be replaced by trained personnel!
16.3
Storage
Store the machine including accessories in a dry, frost-proof and lockable place when not in use.
Cover the machine or store it in the original box to protect it from dust. Make sure that
unauthorized persons and especially children do not have access to the machine. Disconnect the
machine from the power supply and slacken the drive belt, see chapter Replace drive belt.
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
16.4
Disposal
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating equipment in the residual waste.
If necessary, contact your local authorities for information regarding available
disposal options.
If you purchase a new machine or equivalent equipment from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
HOLZMANN MASCHINEN GmbH
Tension the drive belt by pushing the motor with the
drive shaft downwards. Fix the position by tightening
the Allen screws (6).
Finally, screw the side cover of the headstock back on
with the 3 screws (7).
C A U T I O N
N O T E
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Disconnect the machine from the power supply.
Remove the cover (1) of the carbon brush on the
motor and remove the carbon brush.
Insert the new carbon brush into the sleeve (2).
Fix the carbon brush by compressing the spring
and closing the cover.
Repeat this procedure with the opposite carbon
brush.
38
D300F_230V
Publicité
