Publicité
Switch the machine on and off
Risk of injury from parts flying off!
Before switching on the machine, check whether
the face plate and/or the spur center,
the tailstock, the centre punch tip and
the tool rest are fixed.
Make sure that the workpiece is firmly clamped!
Do not machine the workpiece with the tool until the machine has reached the
set spindle speed
Do not increase the spindle speed until the workpiece has reached a regular
runout in its basic shape.
Machine overruns!
After switching off, stay with the machine until the workpiece comes to a
standstill. Never stop the rotation by hand!
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
Always disconnect the machine from the power supply before cleaning,
maintenance or repair work and secure it against unintentional reconnection.
16.1
Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
Remove chips and dirt particles from the machine after each use with compressed air and a
soft brush.
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
HOLZMANN MASCHINEN GmbH
W A R N I N G
N O T E
Switch on
Press the switch-on button (1) of the switch unit.
The rotation starts with a delay of 1–3 seconds.
Switch off
Set the lowest spindle speed with the rotary regulator (2).
Press the switch-off button (3) of the switch unit.
The rotation of the spindle and the workpiece stop only with a delay.
C A U T I O N
W A R N I N G
N O T E
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
36
D300F_230V
Publicité
