Publicité
14.4
Settings
Headstock
Tailstock
Spindle speed
Risk of injury from flying parts!
Always set the lowest spindle speed for unknown types of wood, for new
workpieces and for large workpieces!
Carefully increase the spindle speed!
OPERATION
Only operate the machine when it is in a perfect condition. A visual inspection of the machine
must be carried out before each operation. Safety devices, electrical cables and operating
elements must be checked carefully. Check screw connections for damage and tight fit.
15.1
Operating instructions
When operating the machine, be sure to observe the following instructions:
Take time to familiarize yourself with how the machine works, the tools and the types of
wood.
Ensure that the machine has a stable base.
HOLZMANN MASCHINEN GmbH
C A U T I O N
www.holzmann-maschinen.at
Spur center
Push the spur center into the headstock
receptacle (1) with a jerk.
To remove it, push the fixing rod into the rear end
of the headstock shaft (2). The spur center comes
out of the receptacle.
Face plate
Screw the face plate onto the thread of the
headstock shaft (3).
To loosen the face plate, fix the headstock shaft
with the fixing rod (4) and at the same time
unscrew the face plate with the open-end
wrench (5).
Position
Open the locking handle (6) and move the
tailstock along the machine bed, depending on
the workpiece size.
Fix the locking handle (6) again.
Centre punch tip
Push the centre punch tip into the tailstock
receptacle (7) with a jerk.
To remove it, push the fixing rod into the end of
the tailstock shaft (8).
Set the spindle speed between 750 and 3200 rpm
with the rotary regulator of the switch unit (9).
OPERATION
34
D300F_230V
Publicité
