Publicité
14.2
Electrical connection
Dangerous electrical voltage!
Risk of injury from dangerous electrical voltage!
Connecting the machine to the power supply and the associated checks may
only be carried out by a qualified electrician or under the guidance and
supervision of a qualified electrician!
Check, whether the neutral connection and the protective grounding are working properly.
Check, whether the supply voltage and the frequency correspond to the specifications of the
machine.
Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ± 5 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
Use a supply cable of type H07RN (WDE282) or take the required cross-section of the supply
cable from a current carrying capacity table. Pay attention to the measures for protection
against mechanical damage.
Make sure that the power supply is protected by a residual current circuit breaker.
Connect the machine only to a properly grounded socket.
When using an extension cable, make sure that the dimension matches the connected load
of the machine. The connection power can be found in the technical data, the correlation of
cable cross-section and cable lengths can be found in the technical literature or obtain
information from a specialist electrician.
A damaged cable must be replaced immediately.
14.3
Assemble
Parts of the machine have been disassembled for transport and must be reassembled before use.
Follow the instructions below:
HOLZMANN MASCHINEN GmbH
W A R N I N G
N O T E
www.holzmann-maschinen.at
Mount locking handles
Tailstock
Insert the shoulder screw (1a) through the
spring (1b) into the opening provided in the
locking handle (1c).
Insert the locking handle into the tailstock and
tighten the shoulder screw (1).
Tool rest base
Place the tool rest base crosswise on the
machine bed and move it to the desired
position. Insert the locking handle as described
above (2).
Tool rest
Position the appropriate tool rest in the
opening provided (3), set the desired height
and fix it with the locking screw (4).
If necessary, turn the tool rest.
ASSEMBLY
33
D300F_230V
Publicité
