Publicité
2.2.7 Blade Replaced
Choose this option after replacing the blade to restart the reminder counter. A reminder to
replace the blade again will be displayed after the next 200 hours of operation. Blade is easy
to replace, refer to section 5.5.
2.2.8 Wire Position
Allows user to test the wire position in 'Edge' mode while the mowing motors are switched off
to prevent any damage to the perimeter wire after the initial setup of the wire is completed.
2.2.9 Delay operation
This option allows the user to press GO but delay the operation starting time. It is useful when
you want to start the operation later in the day when the grass is dry and not early in the
morning when the grass is wet (and you have to leave for work).
To use this option, follow the steps below:
- Set the 'Delay operation' to X hours (choose between 1,2,3...or up to 8 hours);
- Switch on the Perimeter Switch (It is operated for 12 hours) and place the mower inside the
lawn towards the perimeter wire;
- Pressing 'STOP' then 'GO' (while holding the 'STOP' button) will change the display to
'Press GO again to skip edge' and at the end of the warming up process, the mower will
stay in place with a message 'Operation delayed – wait...'
- The mower will start the operation after X hours (as set in the 'Delay operation' menu) from
the 'GO' pressing.
2.3 Information
The 'Information' display (refer to figure 2.1) is used for information only, it allows the option to
scroll between the following menus:
2.3.1 Operation
Total time - Indicates the total number of hours the mower has been in operation.
First operation – Indicates the date, in which the mower was first operated.
Figure 2.6
Operation menu
2.3.2 Battery
Battery voltage – Displays the current voltage of the batteries.
Last run times – Indicates the last battery run time in the last 10 operations, the voltage at the
beginning of the operation and the operation date.
Battery
Battery
Battery
Battery
Press GO
Press GO
Press GO
Press GO
Figure 2.7
Battery menu
All manuals and user guides at all-guides.com
Operation
Operation
Operation
Operation
Press GO
Press GO
Press GO
Press GO
Battery voltage
Battery voltage
12.8 25.5 12.7
12.8 25.5 12.7
Last run times
Last run times
Last run times
Last run times
Press GO
Press GO
Press GO
Press GO
23
Total time
Total time
Total time
Total time
253h47m
253h47m
253h47m
253h47m
First operation
First operation
First operation
First operation
Date: 13/03/08
Date: 13/03/08
Date: 13/03/08
Date: 13/03/08
1) 2h34m 25.8V
1) 2h34m 25.8V
1) 2h34m 25.8V
25/05/08
25/05/08
25/05/08
2) 2h32m 25.7V
2) 2h32m 25.7V
2) 2h32m 25.7V
24/05/08
24/05/08
24/05/08
10) 2h27m 25.7V
10) 2h27m 25.7V
10) 2h27m 25.7V
18/05/08
18/05/08
18/05/08
EN
Publicité
