Publicité
This area should be
as the perimeter wire
cannot be laid in slope
EN
Figure 1.9 - Max slope
1.3 Perimeter Wire Setup
Now, knowing the location of the Perimeter Switch and the planning of the wire layout, you can
begin to setup the Perimeter Wire.
1.3.1 Starting Point
Place the Perimeter Switch according to your plan, as
shown in Figure 1.2;
Puncture the plastic covering of the perimeter wire
and pull the wire ends with the plot connector out of
the plastic covering; The connector should be
connected to the wire in the polarity show in Figure
1.10;
The plastic covering is designed as a dispenser for
the wire; so do not remove the wire spool from the
covering;
Peg the beginning of the wire to the ground where the
Perimeter Switch will be located; be sure to leave
spare wire to close the loop at the end of the setup
(Figure 1.11);
Lay the wire from the Perimeter Switch to the lawn;
Start laying the wire to the counterclockwise direction when standing inside the lawn, as show in
Figure 1.11.
Begin pulling the perimeter wire out of the plastic covering and lay it loosely as you walk along
the area of the lawn to the direction shown in Figure 1.11;
layout from the Perimeter Switch
All manuals and user guides at all-guides.com
left out of the
working area
D
x
greater than 15%
(15cm height per
distance of 1m)
Long distance
of RoboRuler
34cm / 14inch
Figure 1.11 –
Direction of Perimeter Wire
C
B
Slope
0-33%
Robomow can mow
areas inside the
0-15 cm
working area with
slope up to 33 cm
per distance of
1 meter (33%)
Figure 1.10 – Pull out the wire from the plastic
covering – do not remove the covering; it is
Connect the wire end to
the left side of the plot
connector (when facing
towards the screws)
Perimeter wire layout in
clockwise direction (as viewed
from the inner side of the lawn)
14
A
Slope
0-15%
100 cm
designed as a dispenser.
Publicité
