Publicité
4.2 Other Operational or Fault Problems
Problem
Encountered
- Wire disconnected from perimeter
switch or from the Base Station.
'Cut wire' indicator
flashing on
Perimeter Switch
or
- Perimeter wire cut
the Base Station
beeps continuously
for 'Cut wire'
- Poor connections
- Twisted cables, or a screw terminal,
'Poor connection'
insulated with insulation tape is not a
indicator flashing on
satisfactory splice. Soil moisture
Perimeter Switch
causes the conductors to oxidize and
or
after a while result in broken circuit.
the Base Station
beeps intermittently
for poor wire
- Perimeter wire too long for one zone
splicing or too long
wire
Robomow doesn't
- Peculiar geometry of the perimeter
complete the edge
- Mower is in deep sleep.
Robomow will not
operate and nothing
will display on the
LCD screen.
- Batteries have been discharged from
lack of charge maintenance.
The Robomow is
- Damaged or unbalanced blade
noisy and vibrates
- Grass is too high in relation to the set
cutting height
Poor quality of
mowing (grass
clippings are left on
the lawn)
- Grass is wet
or
Uneven mowing
results
- Dull blade
- Robomow works too few operations
- Working area is too large
All manuals and user guides at all-guides.com
Probable Cause/Event
31
Corrective/User Action
- Confirm wire is plugged in and wire leads
are firmly attached.
- Walk along perimeter, including islands and
look for obvious cuts or breaks in the wire.
Repair with Robomow wire splice
connectors.
- Check and repair all loose/poor or corroded
connections.
- Use the connectors supplied in the box. It is
waterproof and gives a reliable electrical
connection.
- A maximum perimeter wire length of 500 m
is recommended. Areas requiring longer
lengths should be broken into separate
zones.
- Perform 'Learn edge (refer to 2.1.2.2)
- If not connected to the Base Station/charger
at all times when not in use, the Robomow
will conserve power by entering into a deep
sleep mode. Press the main switch button
(on/off) 3 seconds continuously to wake
Robomow or remove the fuse for 3
seconds.
- It is required for the charger to remain
connected to Robomow when not in use.
Failure to do so can cause permanent
damage to the batteries. Contact your
service provider.
- Check the lawn is free from branches,
stones or other objects that can damage the
blade before operating the Robomow.
- Replace the blade
- It is recommended to cut not more than a
1/3 of the green part of the grass.
- Set the cutting height to a higher position
- Use Robomow more frequently to maintain
your lawn.
- For best cut, operate Robomow when the
grass is dry. It is recommended to mow
grass early afternoon.
- Replace blade.
- Use the Robomow more often per week
- Limit the working area
EN
Publicité
