Publicité
Robomow
1. Child Guard / Safety Guard
This menu option offers a safety feature to help prevent children or others not familiar with the safe
operation of the mower to operate it freely.
2. Lift Sensor
There is Hall-Effect Sensor (Magnetic Position Sensor) located in the front side of
Robomow. In case the front of the mower is raised approximately 1-inch from its resting
position on the ground during blade operation, the blade will immediately stop rotating (< 1
second).
3. Tilt Sensor
There is an optical sensor located in the front side of Robomow. In case the front of the mower is
lifted up towards a vertically position, the blade will stop immediately and Robomow will warn about
it and instruct the user to remove the fuse before lifting Robomow.
4. Bumper Sensor
The bumper is equipped with Hall Effect sensor activates when the mower strikes a solid, fixed
object and when the bumper cover is open. When the bumper sensor is activated, the mower will
stop the rotation of the blade immediately (<1 second), will stop movement in that direction and
reverse itself away from the obstacle.
5. Emergency Stop Button
Located on the control panel, red in color. Pressing this button at any time during operation will
stop all mower movement and stop the rotation of the blade immediately (<1 second).
6. Batteries Fuse
Located below the bumper cover, on the left side of Robomow. Removing the battery fuse will
prevent any operation of the Robomow. It is required to remove the fuse before lifting Robomow
and before any maintenance is done.
7. Two-Step Operator Presence Control
While in manual mode using the remote control, it requires two independent finger actions in order
to engage the mower blade. Once engaged, the mower blade button must remain depressed to
continue blade operation. Once released, the two-step engagement process must be repeated.
8. Electronically Controlled Charging System
Robomow is equipped with an on-board charge control system. This allows you to keep the
charger connected at all times, even after the battery is fully charged. The control system will
prevent an overcharge to the battery and keep it fully charged and maintained for the next use.
9. Sealed Batteries
The batteries that operate the Robomow are completely sealed and will not leak any type of fluids,
regardless of position. In addition, the batteries contain a one-time-use fuse in the event of a short-
circuit or power malfunction.
10. Perimeter Switch and Perimeter Wire
Robomow cannot operate without a perimeter wire installed and activated through the Perimeter
Switch. In the event the Perimeter Switch is turned off or otherwise fails to function, Robomow will
stop operating. Likewise, should a break in the perimeter wire occur Robomow will again stop
operation. A break in the perimeter wire prior to operation will prevent Robomow from operating. It
can only operate within the boundary of the perimeter wire.
All manuals and user guides at all-guides.com
®
Safety Features
7
EN
Publicité
